Mate Pro Direct RF Setup Without Bond App

Purpose / Overview

This guide explains how to manually configure Mate Pro channels without using the Bond Home app. Use this method to set motor technologies and channels directly on the Mate Pro device.

---

Steps

1. Select a Channel

   • Use the LEFT/RIGHT keys on Mate Pro to navigate to the desired channel (01–15).

2. Enter Technology Selection Mode

   • Hold Key 1 + Key 3 for ~3-4 seconds until the LED indicates tech selection mode.

3. Choose the Motor Technology

   • Use UP/DOWN keys to cycle through available technologies (RTS, Nice, Amp, Dooya, etc.).

4. Save the Channel Technology

   • Press STOP to confirm the selected tech for the channel.

5. Repeat for All Channels

   • Program each channel as needed.

   • Channel 00 acts as the master channel—setting its tech will apply the same tech to all other channels.

6. Prepare Motors for Pairing

   • Ensure each motor is in pairing mode before assigning it to a Mate Pro channel.

---

Notes / Tips

• Manual setup is useful if you prefer not to use the app or when app pairing is not available.

• Keep a map of channels and assigned technologies for easier troubleshooting.

• After setup, test each motor to ensure proper response.

---

Troubleshooting / FAQs

Q: Motors do not respond after setup?
A:

• Verify the correct technology mode is selected for each motor.

• Ensure motors are in pairing mode before channel assignment.

• If using multiple motor types, confirm there are no conflicts between channels.

Q: Channel 00 master channel didn’t apply to all channels?
A: Make sure Channel 00 is properly saved after selecting the desired tech, then recheck other channels.