Bond Bridge - Setting Static IP address when using the Bond Home application

Static IP Setups

Setting up on a New Bond Bridge Device

Setting up on an Existing Bond Bridge Device

Setting up (a New Bond Bridge)

  • Go to the WiFi settings for the device the Bond Home application is on.
  • Please make sure your cell data is off or the automatic switch to cell data for bad wifi connections is turned off.
  • Select the BOND WiFi (serial number of your BOND unit).
  • Open a web browser on your device that has the BOND application installed on it.
  • Enter 10.7.42.1 in the browser address bar.
  • Enter the account code.
    • The account code is located in Account info in the Bond Home application settings menu.  The menu is located at the bottom left of the application in Android and the bottom right in iOS.
  • Select Add BOND to Account. 

mceclip0.png

  • Once the Bond is connected to your account Select your WiFi network (Select your Access Point).  
  • Enter in your password.

mceclip1.png

  • Select Advanced

mceclip2.png

  • Choose Static IP

mceclip3.png

  • Enter the IP address, netmask and gateway you want to use
  • DNS and Fallback DNS are optional
  • Select Connect to WiFi.
  • Once the Bond Bridge center ring is solid blue you are all setup.
  • If there are any issues with connecting the BOND, please contact customer service at customerservice@bondhome.io

You can open the BOND application and start adding devices.

 

back to top 

Setting up (on a existing Bond Bridge)

  • Go to the WiFi settings for the device the Bond Home application is on.
  • Please make sure your cell data is off or the automatic switch to cell data for bad wifi connections is turned off.
  • Select the BOND WiFi (serial number of your BOND unit).
  • Open a web browser on your device that has the BOND application installed on it.
  • Enter 10.7.42.1 in the browser address bar.
  • Select your WiFi network (Select your Access Point).  
  • Enter in your password.

mceclip1.png

  • Select Advanced

mceclip2.png

  • Choose Static IP

mceclip3.png

  • Enter the IP address, netmask and gateway you want to use
  • DNS and Fallback DNS are optional
  • Select Connect to WiFi.
  • Once the Bond Bridge center ring is solid blue you are all setup.
  • If there are any issues with connecting the BOND, please contact customer service at customerservice@bondhome.io

You can open the BOND application and start adding devices.

back to top 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Article is closed for comments.