bond bridge - Factory (White) Reset

This reset will delete all of the devices in addition to network settings.  This reset would be used if you were moving to a new location and are going to set the bond up with the fans at that location.  Do not use this reset if you have a problem connecting the bond to your WiFi network.

  • Press and hold the reset switch located next to the USB cable connector until the ring turns White (about 10 seconds). 

  • Once the ring returns to a flashing green color, proceed with setup.
Was this article helpful?
3 out of 7 found this helpful
Have more questions? Submit a request

Comments

0 comments

Article is closed for comments.